My Actifit Report Card: December 10 2024

donating morning Swan to novices and monks, finishing and testing the enclosure for the printer,

Dear friends,

Yesterday morning, my mom, sister and I donated morning Swan meal to the novices and monks from Myo Oo monastery. I just helped them offering the meal; they prepared it early morning. We also donated books, pens and some snack to them. There were about sixty nivices and a few monks.

Then, I tried to finish the installation of electrical control to the 3D printer enclosure. I installed the PTC heater, the blower fan, the power supply unit and finally the acrylic cover sheet for the doors. Then, I made a test run to see if it could achieve the set temperature which was 33°C. I used REX-C100 controller, which has PID control algorithm. It tuned itself to get to the set temperature and took about twenty minutes to get to the temperature. It was long but I think it is not bad at all. The annoying thing was the sound from the blower; so I decided to put it in the garage. I will try 3D printing inside it and show you the print result next time.

Those were some of the activities for yesterday.

@princekham
Myanmar
10th Dec 2024

This report was published via Actifit app (Android | iOS). Check out the original version here on actifit.io

Daily Activity