My Actifit Report Card: December 6 2024

Morning exercises, building 3D printer enclosure

Dear friends,

Yesterday,I did physical exercises early morning for about 30 minutes when I got up and after that I meditated for about twenty minutes. I prepared for the breakfast and after having breakfast, I continued building enclosure for my 3D printer.

(photo below: morning view from my home veranda)

I found that I need to keep the temperature inside the enclosure at 30 to 35 °C. There are two options to implement that. One is to use microcontroller along with PID to controll the on/off heating fan and the other is to use a on/off temperature controller. If the temperature does need to be constant, the latter would work I think. I will install the latter one becasue I already have a on/off controller.

(photo below: building frame for my 3D enclosure)

Then, in the afternoon, I did some house chores and wipe some dust accumulated on the solar panels. I found some leftovers of pigeons on some of them. I think I would get a wiper with a long handle to clean the panels.

Then, I went out to buy some grocery and hinges for the enclosure and continued building it until ate evening. I finally able to install the hinges for the enclore.

After dinner, I meditated for one hour and I was able to complete it without any disturbances or interruptions.

Time flies; a day ended up quickly. Those are some of the activities for yesterday.

@princekham
Myanmar
6th Dec 2024

This report was published via Actifit app (Android | iOS). Check out the original version here on actifit.io

Daily Activity